Mono amplifier - 200W Mono-Stereo Amplifier (Closeout)

Universal, solid and compact are the best words to describe this amplifier.

Universal: A stereo amplifier (2 x 50Wrms or 2 x 40Wrms) or a mono amplifier of 100Wrms. Three possible input sensitivities.

Solid: Overload and short-circuit protection, protection against wrong polarizing of the power supply and thermal protected. Speaker pop protection.

Compact: The heat sink is at the same time the P.C.B. housing.

The amplifier may be used as a built-in module, or it may be free-standing in one of our closets see also options.

RMS output power : 2 x 50W / 4ohm ; 2 x 40W / 8ohm
RMS mono-bridged power : 100W / 8ohm
Total music output : 200W
Harmonic Distortion : 0.01% at 1kHz
Signal-to-noise ratio : 102dB (A-weighted)
Stereo channel separation : 85dB
Damping factor (at 100Hz) : >1000 !
Input impedance : 22Kohm
Input sensitivity : 300mV, 550mV or 1V switchable
Short-circuit and overload protection (max. 10 min.)
op suppression at switch-on and switch-off
Protection against wrong polarization by means of fuses
Thermal protected (max. 1h)
Power supply : + and - 28VDC max.
Consumption 2 x 4ohm or mono-bridge 8ohm : 4A max.
Consumption 2 x 8ohm : 2.5A max.
Dimensions : 210 x 84 x 64mm

Parts List:

Options:

• Mono/Stereo switch type : 8011C
• Sensitivity switch type : 8012IC
• For the integration of one amplifier a plate set HB220921 and a front panel ALP210 are available with one power supply APS200 + transformer 16020 or 22520.
• For the integration of two amplifiers, the plate set HB330922 is available with one power supply APS200 + transformer 30020.
APS200 POWER SUPPLY MODULE FOR K4004 AND K4005
Required transformer:
• VK4005 : 2 x 8 Ohm : 2 x 30VAC / 225VA type 22530
• VK4005 : 2 x 4 Ohm : 2 x 25VAC / 300VA type 30025
• VK4005 : 1 x 8 Ohm : 2 x 25VAC / 300VA type 30025
• VK4004 : 2 x 8 Ohm : 2 x 20VAC / 160VA type 16020
• VK4004 : 2 x 4 Ohm : 2 x 20VAC / 225VA type 22520
• VK4004 : 1 x 8 Ohm : 2 x 20VAC / 225VA type 22520