|Programmable, DPDT, 10 Amp, AC or DC,|
Multifunctional, Digital Time Delay
Timer Function Descriptions
|A. Delay On Operate|
Output relay turned on at end of programmed time interval which is started by CONTROL input or power-on with CONTROL on. Relay turned off by RESET input until next cycle is started. With CONTROL on, turning RESET off restarts timing.
B. Delay On Release
C. Interval On
D. Control-Off Interval On
F. Single Cycle
|power-on with CONTROL on. Relay stays on for equal time interval, then turns off. RESET terminates timing and turns relay off. Turning RESET off does not restart timing.|
G. Control On-Off Interval On
H. Control On-Off Delay
J. Cumulative Delay On Operate
Counter Function Descriptions
|CO. Operate at Preset Count - Normal Mode|
After initializing by momentary activation of RESET input, each on/off signal at COUNT (CONTROL) input increments displayed count in upcounting manner from initial 000 value until preset count, set by thumbwheel switches, is reached and output relay turns on. Additional inputs continue to increment displayed count. Continued counting past maximum count (999) results in a "wrap-around" effect to 000, followed by continued up-counting. Activation of RESET input turns relay off and resets count to zero.
CR. Release at Preset Count - Normal Mode
|relay on. Operation is similar to CO (Operate at Preset Count) except relay turns off at preset count.|
CO or CR. Divide-by-10 Mode
CO or CR. Divide-by-100 Mode
© 1995-2014, All material on this site is copyrighted by HobbyTron.com or the product itself.